BeC R20A Full CPAP System

Introduction:

The BeC CPAP Machine non-invasive continuous positive airway pressure devices are designed for delivery

of positive airway pressure to provide noninvasive ventilation for adult patients

snoring and obstructive sleep apnea (OSA) in home or hospital environment
Through non invasive ventilation, such as wearing masks, the device provides a
single level positive airway pressure on patient’s upper respiratory tract to help
patient breathe easily.

Warnings:

These instructions are for reference only. They cannot replace the expert medical guidance from a licensed healthcare professional for the proper use of this device.
You should read through and understand this manual before use.
This device is not intended to be used to provide life support.
The proper operation of this device may be influenced or disturbed if any of the following conditions exist nearby:
– Electromagnetic fields exceeding 3V/m under the EN/IEC60601-1-2 test conditions.
– The operation of a high frequency device (diathermy).
– Electric shocks from a defibrillator or a short-wave therapeutic device.
– Radiation (such as, x-ray or CT).
– Electromagnetic field (such as, MRI).
Devices have the potential to allow rebreathing of exhaled air. To reduce the chance of this possibility occurring, please observe the following precautions:
– Do not wear the mask for a long time while the device is not in operation.
– Do not block or seal the vent holes in the exhalation port of mask.
If you notice any damage to the device or experience any unusual performance (such as, harsh sounds or unfamiliar odors), quickly disconnect the power supply, empty the water tank, and stop using the device. Once the device is turned off,
Keep the device dry, the tube and mask smooth.
Parameters of the device should only be adjusted by trained medical professional according to actual conditions.
If you have any symptoms of discomfort during the use of the device, please contact your medical professional immediately.
Do not use antistatic or conductive hoses or tubes; Use only breathing circuits provided by your health care professionals, distributor or manufacturer.
Do not tie or seal the ventage, and do not use tape, seals or other substances to block the air inlet when using a mask with exhalation hole or a breathing circuit with an independent air outlet, which may block fresh air and cause suffocation.
Do not cover the device with any objects during use. Otherwise, it may cause
The BeC CPAP Machine non-invasive continuous positive airway pressure devices
-Use Blue Echo Care LLC Medical accessories only, such as mask and breathing tube.
contact your Blue Echo Care LLC representative or local distributor.

suffocation.
Do not wear the mask before the device is in use. Otherwise, it will cause rebreathing of inhaled carbon dioxide. Under certain conditions, rebreathing of exhaled air over several minutes may cause suffocation.
Do not use the device in the presence of a flammable anaesthetic mixture in combination with oxygen or air, or in the presence of nitric oxide.
Keep away from toxic or hazardous steam during use.
The plug must be inserted to power in a vertical direction to ensure normal use.
Periodically (weekly recommended) inspect flexible cords, cables, and power supply devices for damage or abrasion. If damaged, stop using the device and replace it with a new one.
To avoid electric shock, pull the plug off before cleaning the device.
Maintenance of the device can only be carried out by the professional maintenance personnel authorized by the Company.
Do not use this device if the room temperature is higher than 35 ℃, otherwise the temperature of air flow may exceed 43℃, which may cause irritation or damage to your airway.
Do not use this device in direct sunlight or near heating equipment, which may increase the air temperature of the output to unsafe levels.
To avoid electrical shock, disconnect the power cord before cleaning. Do not immerse the device in fluid of any kind.
When using this device, make sure the mask is positioned above the height of the host unit. Failure to do so may cause any condensed water in the Tube to flow into the user’s nose, creating the risk of possible suffocation.
Stop using this device and replace it with a new one if the humidifier is damaged.
Do not touch the heater plate after turning the device off. Let the heater plate cool off before touching.
Be sure that the device is in a place that cannot be accessed or touched by children, who could be entangled, injured, or strangled by the tube.
If you notice an unexplained change in the operation of the device, if the device sounds strange or harsh, if the device and (or) its power supply has fallen or has been misused, if the shell is damaged, or if the liquid flows into the device, do not continue using the device and contact your healthcare professional.

Approved as a class II Medical Device from Health Canada, Medical Device License # 110026 Device Identifier #: CAN-BEC-R20A